Categories
Product Catalog
  • GlueBoss ClipBoss Adhesive Cartridge 400 ML

The 400 mL 1:1 adhesive cartridge can be dispensed with the correct double pump caulk gun, or in a caulk gun with the provided syringe adapter. The ClipBos Thix index allows it to be installed upside down without dripping. ClipBoss bonds to metals, granite, quartz, solid surface, glass and more.

With over 3000psi in strength and a 15 minute set time, ClipBoss is the right adhesive for the job when rodding or bonding clips, Two quadr tips included - Color is neutral only.

ClipBoss Adhesives is a two-part methacrylate, structural rodding and clip bonding adhesive designed for the structural bonding of sink clips, steel and fiberglass rodding materials, and steel and aluminum to solid surface (acrylic and polyester), engineered stone, quartz surfaces, and natural stone products. Combined at a ratio of 1:1, ClipBoss has a working time of 4 to 8 minutes and achieves nearly 90 percent of its ultimate strength in 10 to 15 minutes at room temperature curing. ClipBoss provides high strength bonds to acrylic solid surface, polyester solid surface (both filled and unfilled), and alloy solid surface (combinations of both acrylic and polyester solid surface resins) and the steel clips, rods, fiberglass and other materials. ClipBoss bonds very strongly to steel, stainless steel, and aluminum metals. ClipBoss is NOT UV STABLE, AND WILL YELLOW OVER TIME and must not be used to create imperceptible seams in countertops. However, this yellowing will not affect bond performance, but will affect bond appearance.

Directions:
ClipBoss resin (Part A) and activator (Part B) are flammable. Contents include Methacrylate ester and acids. Keep containers closed after use. Wear gloves and safety glasses to avoid skin and eye contact. Wash with soap and water after skin contact. In case of eye contact, flush with water for 15 minutes and get medical attention. Harmful if swallowed. Keep out of the reach of children. Keep away from heat, sparks, and open flames. Do not smoke cigarettes or anything else while handling or near the product. Refer to the ClipBoss Material Safety Data Sheet for more complete safety instruction. To assure maximum bond strength, surfaces must be mated together within the specified working time, and all clamps affixed within that time. Use sufficient material to ensure that the joint is completely filled when parts are mated and clamped. Avoid over clamping parts, which may cause a dry joint or a joint starved of adhesive. All adhesive application, part positioning, fixturing, and clamping should occur before the working time of the adhesive has expired. After the indicated working time, parts must remain undisturbed until the fixture time is completed. Components bonded, adhesive, and shop temperature can have a significant effect on the work and fixture time of the adhesive. Application of ClipBoss adhesive at temperatures between 65°F and 85°F (18°C and 30°C) will ensure proper cure. Temperatures below 65°F (18°C) will slow cure and fixture speed. ClipBoss adhesives will still react, but will take longer. Temperatures above 85°F (18°C and 30°C) will increase cure and fixture speeds, and there’s a risk that the adhesive will be hardened or too thick to bond materials. The viscosities of ClipBoss adhesives are affected by temperature.


Write a review

Please login or register to review

GlueBoss ClipBoss Adhesive Cartridge 400 ML

  • Brand: Tenax
  • Product Code: GB-CB-400
  • Availability: In Stock
  • $34.90