Husqvarna Target Block Saw GM2090H - 8hp gas powered Guardmatic

This is the Husqvarna 20" Guardmatic block saw with a 8hp Honda Cyclone engine.

This 8hp unit features:

• 20" blade capacity to cut 8x8x16" block in one pass.
  
• Only two pivot points for reduced saw maintenance and longer diamond blade life.
• Sealed lifetime lubricated bearings - no greasing required!
• Spring tension counter-balanced cutting head, making raising and lowering easy.
• Cutting head height can be controlled with a convenient crank control and foot pedal.
• Open throat design allows passage of large pieces of materials to be cut.
• Field installable blade shaft assembly.
• Electric water pump is self-priming and thermally protected.
• Provides consistent water delivery for maximum blade protection.
• Integrated water system easy to clean and service.
• Brass water tubes are built into either side of the guard for long life and easy service.
• Patented sta-levelblade guard
• Large conveyor cart is a durable, cast aluminum cart for strength and rigidity and is 16-5/8" long x 22-3/4" wide.
• The vulcanized rubber top is permanently bonded to the cart and has a durable ruler for quick, easy measurements.
• The included aluminum rip guide assures straight cuts.
• One-year limited warranty
  

We guarantee we will beat all offers on this saw from any authorized dealer!

* Free shipping to any commercial address in the continental USA. For residential deliveries please add $100.00.

NOTE: Commercial Addresses constitute as areas zoned as COMMERCIAL and INDUSTRIAL
If you operate your business out of your home, that is NOT considered a commercial address!!

NO SALES TAX IN: ALABAMA, ALASKA, ARKANSAS, COLORADO, DELAWARE, FLORIDA, GEORGIA, IDAHO, ILLINOIS, INDIANA, KANSAS, MICHIGAN, MINNESOTA, MISSOURI, MONTANA, NEW HAMPSHIRE, NEW JERSEY, NEW MEXICO, NEW YORK, NORTH CAROLINA, NORTH DAKOTA, OHIO, OKLAHOMA, OREGON, TEXAS, UTAH, VERMONT, VIRGINIA, WASHINGTON, WASHINGTON D.C., WEST VIRGINIA, WYOMING